Thingiverse
Bronze Light
by Gothampixel
29
Downloads
41
Likes
2
Makes
This is just a test print. At this scale the wall thickness up top is .6mm in an attempt to make it as clear as possible.
This was my first attempt at switching filament mid print. The Base was printed in Colorfabb Bronzefill and the top is XT clear. XT requires a much higher printing temp so the transition wasn't as smooths as it could have been.
This was my first attempt at switching filament mid print. The Base was printed in Colorfabb Bronzefill and the top is XT clear. XT requires a much higher printing temp so the transition wasn't as smooths as it could have been.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
