Broom Holder (double & triple)

Remixed Broom Holder based on the original design by @o2bric. This remix expands on the original model with several practical improvements and variationsaimed at better adaptability and material efficiency. Body: Can be printed in PLA or PETG (suggested).Collar: must be printed in TPU 95A or TPU 98A. Changes and additions:Created a triple version (holds up to 3 brooms).Created a double version (for 2 brooms).Reduced the baseplate surface area to save material while maintaining strength.Optimized material usage for faster and lighter prints.Added multiple 9 mm screw holes for flexible wall mounting, easily adaptable if you want to reuse existing holes from another holder (as tested in my setup).In practice, during testing, it held securely with just two screws, though more holes are available if needed.Assembly InstructionsAssembly for this broom holder is straightforward (triple holder shown below, the same applies for double) Attach each green broom clip to the black backplate by alig