MakerWorld
Other House Models
Zum Modell
Broom Holder
27
Downloads
9
Likes
19
Makes
Simple broom holder using only gravity and friction! This is mounted to the wall using two #8 screws. The PLA can be slick, causing the broom handle to slip. To counteract this, a grippy surface is needed on the inside faces of the U-shaped arm. To achieve this, I simply applied a layer of E6000 glue and let it cure. This worked to create a grippy surface, although there are other ways to achieve the same effect. I printed this out of Overture Super PLA+. As always happy printing, and let me know how it goes in the comments!
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
