Thingiverse
Broomhandle Cap
door wd5gnr
27
Downloads
19
Likes
1
Makes
The cap off my cheap broom broke, so I sort of redid it as a CAD model. The original was a little shorter, and had a concave cap under the hanging slot. I made it convex for no particular reason.
If the hole is a little tight, you can always go into the slicer and scale the X and Y by a small amount (say 1.01 or 1%).
If the hole is a little tight, you can always go into the slicer and scale the X and Y by a small amount (say 1.01 or 1%).
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
