Thingiverse
Broomholder Solidworks
von Rebewppilihp
4.6k
Downloads
3k
Likes
6
Makes
I rebuilded the Latching Broom holder from Greg Frost (https://www.thingiverse.com/thing:2029895) in Solid Works.
So for everyone using Solidworks..here you go !
The screws i used are: DIN EN ISO 4762 - M3x20.. (thanks PsiborgJhin for bringing this to my attention ;) )
So for everyone using Solidworks..here you go !
The screws i used are: DIN EN ISO 4762 - M3x20.. (thanks PsiborgJhin for bringing this to my attention ;) )
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!