Thingiverse
Bruno_Cup
von juewei
6
Downloads
10
Likes
0
Makes
A small shotcup.
I was shown a 3D-print of this cup, and asked to print some more of them.
But then I could not find it here on thingiverse, nor elsewhere in reasonable time.
Re-creating it with FreeCAD 0.19 was a nice excercise.
It is composed of 3 bodies:
* The cup body itself is drawn as a half vertical crosssection spline, then rotated about the vertical axis.
* The handle is drawn as an elliptic crosssection and a travel path.
* A small box to cut away a part of the handle that extended into the inside of the cup.
Objects created from boolean operation of multiple bodies in FreeCAD-0.19 just work fine.
The cup is 31mm high, has 38mm outer diameter, and a wall thickness of ca 2.5 to 3mm.
May all your prints be watertight!
I was shown a 3D-print of this cup, and asked to print some more of them.
But then I could not find it here on thingiverse, nor elsewhere in reasonable time.
Re-creating it with FreeCAD 0.19 was a nice excercise.
It is composed of 3 bodies:
* The cup body itself is drawn as a half vertical crosssection spline, then rotated about the vertical axis.
* The handle is drawn as an elliptic crosssection and a travel path.
* A small box to cut away a part of the handle that extended into the inside of the cup.
Objects created from boolean operation of multiple bodies in FreeCAD-0.19 just work fine.
The cup is 31mm high, has 38mm outer diameter, and a wall thickness of ca 2.5 to 3mm.
May all your prints be watertight!
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
