Thingiverse
Bryton mount base for MTB stem
by DesmoDog
0
Downloads
0
Likes
0
Makes
This is to mount a Bryton bike computer to an MTB stem. The mounts included with my Rider 450 were worthless for my YT Jeffsy, so I made this up to hold it on the stem. Once it's printed you can attach the stock Bryton 1/4 turn mount using the thicker rubber base and one of the larger rubber rings.
Print one of the posts and two buttons. Posts do not require supports but I did use them on the buttons. The difference between the two posts (V3 and V4) is V4 has a dog paw emboss on it. Orient parts as shown in the third photo.
Requires two 4 x 0.7 x 10 bolts to hold the buttons on the side of the post.
I have used this for almost 9 whole miles so far and it works great.
Print one of the posts and two buttons. Posts do not require supports but I did use them on the buttons. The difference between the two posts (V3 and V4) is V4 has a dog paw emboss on it. Orient parts as shown in the third photo.
Requires two 4 x 0.7 x 10 bolts to hold the buttons on the side of the post.
I have used this for almost 9 whole miles so far and it works great.
DesmoDog also publishes on
34 additional models across 1 more platforms
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!