Thingiverse
BSG Viper Replacement Jet Engine Storage
por BestBattlePlan
89
Descargas
72
Likes
0
Makes
Update 12/15/18 I fixed the top and bottom pieces so they come together closer to the center of the jet engine...
If you are planning to make the Viper Launch Tube...
https://www.thingiverse.com/thing:3229636
You can stack up some spare Jet Engines for later use. The stack separates. I'm using PLA strands to line up the stacks up to 3 high. OSHA won't allow any higher ;)
Will post a pic of final make. These were designed at 1/32 scale.
I printed the Jet in 4 colors. Orange for the end cap (1 - 34) Black for the nacelle (35 - 134) Gray for the body (135 - 503) and blue for the tip. Those layer numbers were determined using Cura and a .15mm layer height
If you are planning to make the Viper Launch Tube...
https://www.thingiverse.com/thing:3229636
You can stack up some spare Jet Engines for later use. The stack separates. I'm using PLA strands to line up the stacks up to 3 high. OSHA won't allow any higher ;)
Will post a pic of final make. These were designed at 1/32 scale.
I printed the Jet in 4 colors. Orange for the end cap (1 - 34) Black for the nacelle (35 - 134) Gray for the body (135 - 503) and blue for the tip. Those layer numbers were determined using Cura and a .15mm layer height
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
