Btt Eddy Bracket - Ender 5

Bracket for mounting the BTT Eddy Current Sensor on the Ender 5/Ender 5 Pro.

I went through quite a few iteration on this bracket to make sure its rigid, the correct height from the bed.

Printing is easy, just print flat. Due to the position from the hot end there is no need for any specific material, I have printed in PLA and it works fine.

X & Y offsets from the nozzle are:

x_offset: -51.2
y_offset: -1.51

For those using Klipper I went with the following settings for bed mesh:

mesh_min: 10, 10
mesh_max: 158.8, 208.49
probe_count: 9, 9

Thats It!