Thingiverse
BTT Filament Sensor Mount Remix.
por vk2rf
2
Descargas
2
Likes
0
Makes
Original from which this is remixed: https://www.thingiverse.com/thing:5435066
I use the BigTreeTech sensor with Octoprint and the "Filament sensor reloaded" plugin, utilizing the following GPIOs :3,3v (Pin 17), GND (Pin20) & a sensor GPIO24 (Pin 18). See manual here:
https://shop.zen3d.hu/wp-content/uploads/2022/06/smart-filament-sensor-module-manual201125.pdf
The original is terrific, (thanks to Kubikossi) but it can hit the top rail and therefore limits the height of models.
So I remixed it.
1) Added 20mm width so the BTT sensor clears the top rail all the way up.
2) Added extra length at the bottom plate connection near the extruder. 2nd Screw now is also fixed through this mount (more stable)
3) Moved the lowest filament guide hole to more accurately align with the extruder input.
I use the BigTreeTech sensor with Octoprint and the "Filament sensor reloaded" plugin, utilizing the following GPIOs :3,3v (Pin 17), GND (Pin20) & a sensor GPIO24 (Pin 18). See manual here:
https://shop.zen3d.hu/wp-content/uploads/2022/06/smart-filament-sensor-module-manual201125.pdf
The original is terrific, (thanks to Kubikossi) but it can hit the top rail and therefore limits the height of models.
So I remixed it.
1) Added 20mm width so the BTT sensor clears the top rail all the way up.
2) Added extra length at the bottom plate connection near the extruder. 2nd Screw now is also fixed through this mount (more stable)
3) Moved the lowest filament guide hole to more accurately align with the extruder input.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!