Thingiverse

BTT PI TFT50 Case

von mikes2277

205 Downloads

106 Likes

2 Makes

### Update 5/27/2022
I added support for V2.0 of the PITFT50. Use "BTT-PITFT50 V2 Case - Rear Pi Cover.stl" and "BTT-PITFT50 V2 Case - Rear Screen Cover.stl". I tested with 2 different TFT50 V2.0 and I noticed that BTT is not very consistent on where they solder the posts that the Pi mounts to. You may need to lightly file the "BTT-PITFT50 V2 Case - Rear Screen Cover.stl" to get it to close properly depending on how far off your posts are.

### BTT PI TFT50 Case
This will allow you to mount the Big Tree Tech (BTT) PI TFT50 screen (V1.0 and V2.0) to any 2020 extrusion.

### Required Hardware
* 12 - M3x8mm - Screen frame and mounting bracket to rear Pi cover
* 4 - M3x10mm - Cooling fan to rear Pi cover
* 1 - 4010 5v fan (https://www.amazon.com/gp/product/B07WJT4XJK/)
* 1 - M3x20mm - For the mount pivot
* 1 - M3 nut - For the mount pivot
* 4 - M2.5x25mm - Rear Pi case, through the Pi, into the BTT PITFT50 mounting posts
* 2 - M3x6mm - Mount to the 2020 extrusion
* 2 -

big tree tech bigtreetech BTT BTT PI TFT50 BTT PITFT50 BTTPITFT50 CR-10 CR-10s CR-10S PRO CR-10S PRO V2 CR10 cr10s CR10S PRO cr10s pro v2 PiTFT50 TFT50 touch screen Touchscreen big tree tech bigtreetech BTT BTT PI TFT50 BTT PITFT50 BTTPITFT50 CR-10 CR-10s CR-10S PRO CR-10S PRO V2 CR10 cr10s CR10S PRO cr10s pro v2 PiTFT50 TFT50 touch screen Touchscreen

Quelle

Thingiverse

Was du zum Drucken brauchst: Mittel Niedrige Konfidenz

Einteilig Hardware nötig

Supports 1/3

Zusammenbau 0/3

Einstellungen 1/3

Druckbett 0/3

Nachbearbeitung 1/3

Drucker

FDM / FFF

Dateiformat