BTT TFT35 V2 Display Case

I designed this case to hold the BigTreeTech TFT35 V2 display on my Ender 3 Pro since this display is not sized to fit into the stock display holder. I had ordered an SKR Mini E3 control board that came in a package with this display, unfortunately I saw pictures of the TFT35 V3 and thought that it was the V2 I ordered. I didn't open this display up until after I had installed the SKR board so rather than take the board out again, I decided to design a case that would hold the display and mount to my Ender 3 Pro.

NOTE: THE BACK PLATES ARE SHOWN ABOVE BEING PRINTED WITH THE FLAT SIDES UP. THEY ARE MEANT TO BE PRINTED WITH THIS SIDE AGAINST THE BED. I ASSUME THIS IS DUE TO THE WAY INVENTOR PRODUCED THE .STL FILES. JUST FLIP THEM IN CURA IF NEEDED SO YOU DO NOT NEED TONS OF SUPPORTS!

The printed part files are:

BTT TFT35 V2 REV 1 Face Plate - This is the front half of the display case. The V2 display is secured to this plate and there is a hole that allows access to the res