Thingiverse
Bubble Shift Knob (Logitech) Remix
por Lock_RC
22
Descargas
16
Likes
0
Makes
A fix to J2J3J4's Bubble Shift Knob
Increased hole size to fit over shifter shaft.
Mating surface added inside the hole to interface with D-cut shaft to prevent spinning.
I didn't have a screw driver long enough to attempt to use the same fastener that's on the shifter already, but it is a good enough friction fit where the concern for the knob coming off is minimal.
Slight sanding needed to allow for a good fit between the two parts.
Increased hole size to fit over shifter shaft.
Mating surface added inside the hole to interface with D-cut shaft to prevent spinning.
I didn't have a screw driver long enough to attempt to use the same fastener that's on the shifter already, but it is a good enough friction fit where the concern for the knob coming off is minimal.
Slight sanding needed to allow for a good fit between the two parts.
Lock_RC también publica en
18 modelos adicionales en 1 plataformas más
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
