MakerWorld
Festivities
Zum Modell
Bubblelight Candleabra
10
Downloads
16
Likes
5
Makes
Made this as I have tons of these lights, but hate putting them on the tree. So I made this little stand to hold a 7 segment set of these lights. Can easily print in multi color on the “candle sticks” by pausing at layer 21 and doing a spool swap-- or if you have an AMS. To assemble:Push the bubble light socket through the bottom of the candle stick upwards. You may have to bend the clip all the way down for it to slide through.Repeat step 1 until all 7 sockets are through. (I recommend starting with the middle or very shortest one first.)Place the light sockets into the small end caps. The larger openings are for the wiring. it should align with small opening on the candle sticks.Using super glue or something similar, glue the caps into place.Feed the plugs out the back openingscrew the top plate and bottom enclosure together with m2x8 screws. screw the bulbs in and plug in and enjoy!
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!