MakerWorld
Other Hobby & DIY
Zum Modell
buckle
452
Downloads
87
Likes
233
Makes
Hello, I propose a buckle for 20 mm tapes and a maximum thickness of 1 mm with quick release.This buckle guarantees a fast and safe snap closure. Once closed it is easier for it to break rather than to open or slip out due to the traction of the tape.I printed the buckle in PETG, but printing it in PLA works the same.The buckle is printable without supports because I inserted two small supports in the most critical part that will be removed once the printing is finished. Boost Me
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
