Bugs in the Kitchen Base fixed
von creatorjames
0
Downloads
2
Likes
0
Makes
A base for the board game Bugs in the Kitchen.
I remixed the 2015 version I found on thingiverse because when I printed the 2015 version the silverware would spin too easily.
This version is 0.6mm wider in both directions making for a much better fit.
I also removed parts of the base so this one looks more like the original base.
This has been tested and works very well. Prints in about 10 minutes with a 0.6mm nozzle.
I remixed the 2015 version I found on thingiverse because when I printed the 2015 version the silverware would spin too easily.
This version is 0.6mm wider in both directions making for a much better fit.
I also removed parts of the base so this one looks more like the original base.
This has been tested and works very well. Prints in about 10 minutes with a 0.6mm nozzle.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
