Buick Remote Holder

I made this to hold the remote for my grandpop's 2004 Buick Century. Should be compatible with some other Buick/GM car remotes from the time too. The plastic around the keyring hole is thin and tends to break. You can use this holder to attach a broken remote to a keychain again. It's a fairly rough model (I'm no expert at CAD), but does the job fairly well. Adding some glue will keep the remote in very snuggly but it should stay in place fine without it. The model can also be scaled down a few mm for a tighter fit. Printed on a Replicator 2 with PLA.

I've included .STL files that will likely need to be scaled up before printing, as the CAD program I use does this incorrectly. The outer part dimensions are roughly 48.0mm x 68.7mm. The two parts are similar but one wraps around the remote more than the other.