Build Plate Holder for Sleek Riser

I have made an attachment for the AMS sleek risers linked here. I have an AMS 2 and I am not sure if it is slightly wider than the AMS 1. When I printed this riser my AMS 2 would not sit nicely and was a bit wobbly. I thought why not add a spacer to tighten up the fit between the tabs and the slots in the AMS. And at the same time, why not fit a few slots for a built plate or two. You have this model now! It fits three build plates. The fit is tight as I did not want to impact any other functions of the AMS riser. If you have the AMS 2, there is still a gap for the inlet port under the AMS 2. https://makerworld.com/en/models/495310-x1c-sleek-riser#profileId-415186https://makerworld.com/en/models/855351-ams-sleek-riser-with-led-strip#profileId-853145