Thingiverse
Building Blocks
von raylast
3
Downloads
2
Likes
0
Makes
The grooved generic building blocks design is aimed at allowing people to print and build custom 0.5" frames or enclosures and fill the walls in with thin panels of other materials by sliding them in the grooves. Alternatively, the grooves provide a friction surface for thicker panels.
My intention was to build a compact enclosure for my printer with walls made from those ~1mm thin plastic cutting boards.
The idea behind the three grooves is so that either one wall can be installed in the middle (or any of the other two positions) or two walls installed on either end thus resulting in an air gap between them for better thermal isolation.
Upload backlog:
Variable length - screw
45° angle
60° angle
30° angle
Curved block - x° radius
Hinge block
Adapter to extruded aluminum slots
Specialty parts specific to the CR-6 SE
Distant future:
Parametric blocks
My intention was to build a compact enclosure for my printer with walls made from those ~1mm thin plastic cutting boards.
The idea behind the three grooves is so that either one wall can be installed in the middle (or any of the other two positions) or two walls installed on either end thus resulting in an air gap between them for better thermal isolation.
Upload backlog:
Variable length - screw
45° angle
60° angle
30° angle
Curved block - x° radius
Hinge block
Adapter to extruded aluminum slots
Specialty parts specific to the CR-6 SE
Distant future:
Parametric blocks
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
