Bulbasaur planter with base

So i really liked the bulbasaur planter from http://www.thingiverse.com/thing:381599 but wanted to make it a little simpler and to make sure that when i accidentally over water the plant that i wont make a mess.

This was printed using 20% infil at the size it is in the .stl. The original was printed at 10% but this is going to be in an office so I wanted it a little stronger.

print with no raft and no supports. My print speed with 30 for the first layer and 60 for the rest of the print, and temp using PLA plastic was 220 C for the extruder and 60 C for the print bed.

Note: the base doesn't quite fit perfectly, you may need to either upscale it or sand it a little to get the piece to sit inside of it.