Thingiverse
Bulbasaur Pumpkin Tealight Remix
von BlackhartFilms
2k
Downloads
1.5k
Likes
32
Makes
This is a remix of the [highpoly bulbasaur](https://www.thingiverse.com/thing:1576163) combined with the [snap-lid jack-o-lantern](https://www.thingiverse.com/thing:525781) made for a friend who wanted a halloween Pokemon like one she'd found on Etsy.
I'll be printing mine in PLA, then finishing with a coat of resin (XTC-3D) and white primer so she can decorate it how she wants.
*Recommended to only use LED flickering tealights- I would never recommend using actual candles with any 3D printed design!*
___
**Edit 10/23/2018: I discovered that the original Makies pumpkin I was remixing had separated shells in the lid which made the slicer think to add a top layer where it wasn't needed, made the print weak and prone to sheering off. I've split the bodies and boolean combined them again into one proper object. Updated models are marked v2.**
I'll be printing mine in PLA, then finishing with a coat of resin (XTC-3D) and white primer so she can decorate it how she wants.
*Recommended to only use LED flickering tealights- I would never recommend using actual candles with any 3D printed design!*
___
**Edit 10/23/2018: I discovered that the original Makies pumpkin I was remixing had separated shells in the lid which made the slicer think to add a top layer where it wasn't needed, made the print weak and prone to sheering off. I've split the bodies and boolean combined them again into one proper object. Updated models are marked v2.**
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!