MakerWorld
Electronics
Vai al Modello
Bullet Camera Flat Surface "Tripod" Holder
1
Download
0
Likes
0
Makes
I installed a few Yi Camera Outdoor cameras in my family's cottage, and some of them were not installed attached to a wall and needed to be installed flat on a surface, for that reason I need something to hold it in a certain orientation and tilted at a certain angle, so this “tripod” was designed. I used two ¼" hex nuts and two ¼" bolts to allow to change the tilt of the camera on a stable surface.
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!
