Thingiverse
Bumpy Back Spinner
door H0wdy
1
Downloads
1
Likes
0
Makes
Hey guys I like spinning scissors as a fidget toy but I wanted something safer so I made this.
The Tpu ring is for smaller fingers the main hole is 24.7mm and the smaller Tpu ring makes it 20mm.
The Tpu bumper is for the tip side it is so if you hit something while your spinning it wont break it.
If I make any changes I will post them here. Happy Printing!
Print 100% infill. 5 Walls and 5 top and bottom layers. No support. I did a brim and cleaned it up after.
The Tpu ring is for smaller fingers the main hole is 24.7mm and the smaller Tpu ring makes it 20mm.
The Tpu bumper is for the tip side it is so if you hit something while your spinning it wont break it.
If I make any changes I will post them here. Happy Printing!
Print 100% infill. 5 Walls and 5 top and bottom layers. No support. I did a brim and cleaned it up after.
H0wdy publiceert ook op
8 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
