Thingiverse
Bunny Pot
di bobross96
7
Download
24
Likes
0
Makes
This is a modified version of https://www.thingiverse.com/thing:752379
A bunny pot! A bit of a pain to print, I recommend 0% infill, 0.6mm layer height and a 0.8mm nozzle, with at least a 0.3mm gap at the support interface. may print better with organic supports. Make sure to enforce no supports on the inside of the watering tube, as they're really hard to remove. Might also be a good idea to enable ironing so the bottom of the pot is actually waterproof.
The "pot" part is a little small, but would work nicely for a succulent.
A bunny pot! A bit of a pain to print, I recommend 0% infill, 0.6mm layer height and a 0.8mm nozzle, with at least a 0.3mm gap at the support interface. may print better with organic supports. Make sure to enforce no supports on the inside of the watering tube, as they're really hard to remove. Might also be a good idea to enable ironing so the bottom of the pot is actually waterproof.
The "pot" part is a little small, but would work nicely for a succulent.
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!
