Thingiverse
Animals
Go to Model
Bunny Zebra
49
Downloads
54
Likes
0
Makes
This is a design produced using a technique from our SIGGRAPH 2014 paper [By-Example Synthesis of Structurally Sound Patterns](http://www.jdumas.org/publication/2015/sfsyn/).
### Printing
The file are provided "as-is", without any warranty. It prints fine on a powder-bed printer such as the ZCorp 450. In our original publication, we printed most of our designs on filament printers (e.g. Ultimaker 2). We used additional support structures (with an extra hole at the base of the bunny). The supports were removed afterwards (which takes time).
On the photo attached to this design, the model has been printed as is, on a ZCorp 450. Since the powder is very brittle, be careful esp. around the paws and the ears, as there is a higher chance things might break in these areas.
### Citation
You are free to use this data for personal or academic purposes. If you do so, we kindly ask you to cite our work. See our [project page](http://www.jdumas.org/publications/sfsyn), or [this link]
### Printing
The file are provided "as-is", without any warranty. It prints fine on a powder-bed printer such as the ZCorp 450. In our original publication, we printed most of our designs on filament printers (e.g. Ultimaker 2). We used additional support structures (with an extra hole at the base of the bunny). The supports were removed afterwards (which takes time).
On the photo attached to this design, the model has been printed as is, on a ZCorp 450. Since the powder is very brittle, be careful esp. around the paws and the ears, as there is a higher chance things might break in these areas.
### Citation
You are free to use this data for personal or academic purposes. If you do so, we kindly ask you to cite our work. See our [project page](http://www.jdumas.org/publications/sfsyn), or [this link]
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
