Thingiverse
busines card holder
door paulokareka
7
Downloads
11
Likes
0
Makes
PT-Br
Corrigido o erro que estava apresentando de o circulo inferior não deixava o restante da peça tocar a mesa.
Se estiver usando o Simplify3D, deve ir em malha e em separar as superfícies, pois caso contrario ele ira deixar onde esta o circulo sem preenchimento.
EN
Fixed the error that was showing that the lower circle did not let the rest of the piece touch the table.
If you are using Simplify3D, you should go in mesh and separate the surfaces, otherwise it will leave the circle where it is without filling.
Corrigido o erro que estava apresentando de o circulo inferior não deixava o restante da peça tocar a mesa.
Se estiver usando o Simplify3D, deve ir em malha e em separar as superfícies, pois caso contrario ele ira deixar onde esta o circulo sem preenchimento.
EN
Fixed the error that was showing that the lower circle did not let the rest of the piece touch the table.
If you are using Simplify3D, you should go in mesh and separate the surfaces, otherwise it will leave the circle where it is without filling.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!