Thingiverse
Button for CB Microphone
by tghost8
6
Downloads
3
Likes
0
Makes
The button for our CB radio at work broke so I made this to replace it.
When it gets imported into Cura, it up scales it probably because Sketchup uses standard and Cura is metric, so when i printed it I set the x length to 45mm, and it worked perfectly. Once it's printed you may need to sand the little pegs a bit to get it to fit just right. I used supports as well.
When it gets imported into Cura, it up scales it probably because Sketchup uses standard and Cura is metric, so when i printed it I set the x length to 45mm, and it worked perfectly. Once it's printed you may need to sand the little pegs a bit to get it to fit just right. I used supports as well.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
