Button mount for height adjustable desk system, Linak

I needed to fit an old height adjustable desk system to a new tabletop. Needed a mount for the button, so i made this.

Printed in the pictures on a CR10 s4 with volcano hot end 1,2 mm nozzle.

Print printable without support standing on the front face.

Screws into the tabletop with two screws, and sits very tight.

in the original print the tolerance between the button and the 3d print was 0,2. That was too little for me, so i changed it to 0,4. This attribute can be changed in the Attribute editor of Fusion 360, and updates fully (see the attached Fusion 360 files).