Thingiverse
C-bot proximity sensor bracket
von AK_Eric
19
Downloads
11
Likes
0
Makes
This is a simple bracket to hold a LJ12A3-4-Z/BY proximity sensor to the back of the C-Bot's direct-drive plate. The "normal" hole has a 14mm diameter. The "big" file has a 20mm diameter.
Full blog post describing how to hook up every facet of this sensor with RepRap Firmware and RADDS:
http://www.akeric.com/blog/?p=4062
Full blog post describing how to hook up every facet of this sensor with RepRap Firmware and RADDS:
http://www.akeric.com/blog/?p=4062
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
