Thingiverse
C-Clamp webcam shutter
by Tperm
0
Downloads
2
Likes
0
Makes
Found a webcam shutter but it didn't have a method of applying so i decided to add a c-clamp.
Print info for the original webcam shutter:
Intended print setting (tested on Ender3 0.4mm nozzle): INITIAL LAYER HEIGHT= 0.25mm, LAYER HEIGHT= 0.15mm,
Print speed (PETG): INITIAL LAYER= 15mm/s, INFILL= 30mm/s, WALL=15mm/s (print time about 4minutes)
Material: Only tried and printed using PETG although other rigid materials should probably work just fine.
Print info for the original webcam shutter:
Intended print setting (tested on Ender3 0.4mm nozzle): INITIAL LAYER HEIGHT= 0.25mm, LAYER HEIGHT= 0.15mm,
Print speed (PETG): INITIAL LAYER= 15mm/s, INFILL= 30mm/s, WALL=15mm/s (print time about 4minutes)
Material: Only tried and printed using PETG although other rigid materials should probably work just fine.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
