Thingiverse
C13 Power Brick
door atanasovgoran
21
Downloads
17
Likes
0
Makes
The printed model in the photo is taller, I fixed the model to be at 30mm,
according to the specs of the C13 standard, that makes it only possible to solder the cables because there is not enough space for connectors.
I also I didn't had the right cable so used two cables for every connection.
I sealed it with ABS slurry used as a glue, it looks horrible, but is not supposed to be seen, you could have better results if you are careful.
If you have any suggestions please feel free.
according to the specs of the C13 standard, that makes it only possible to solder the cables because there is not enough space for connectors.
I also I didn't had the right cable so used two cables for every connection.
I sealed it with ABS slurry used as a glue, it looks horrible, but is not supposed to be seen, you could have better results if you are careful.
If you have any suggestions please feel free.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!