C270 Camera Mount 2020
von evil_k
23
Downloads
16
Likes
0
Makes
Could not find a mount that suited my needs for holding a C270 camera inside an enclosure of 2020 extrusion so came up with this.
Need m3x25 machine screw and nylock nut to hold the camera to the mount. Try to keep the little plastic bushing that is in the mounting hole on the rear of the camera. Mounts to the 2020 extrusion with m3 hardware.
This is a tight fit to the camera - to get the m3 bolt hole to align with the hole in the back of the camera.
Printed at 0.2mm layer heights with 0.4mm nozzle. I printed this in PETG, but most material will work.
The focus ring and face of the camera are from Thingiverse - you will have to search for the parts.
Added a version that should work for 3030 aluminum extrusion. I just changed the one dimension from 20mm to 30mm - hope it works okay - not tested as do not have any 3030.
Need m3x25 machine screw and nylock nut to hold the camera to the mount. Try to keep the little plastic bushing that is in the mounting hole on the rear of the camera. Mounts to the 2020 extrusion with m3 hardware.
This is a tight fit to the camera - to get the m3 bolt hole to align with the hole in the back of the camera.
Printed at 0.2mm layer heights with 0.4mm nozzle. I printed this in PETG, but most material will work.
The focus ring and face of the camera are from Thingiverse - you will have to search for the parts.
Added a version that should work for 3030 aluminum extrusion. I just changed the one dimension from 20mm to 30mm - hope it works okay - not tested as do not have any 3030.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
