Cabin

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm The Model is 200x200mm in size. You can change X and Y but Z must remain the same.You may print at higher layer heights below the Min Depth of 0.48mmActual Depth is 2.2mm Filaments Used:PLA BambuLab Basic Gray Transmission Distance: 2PLA BambuLab Basic Yellow Transmission Distance: 6PLA BambuLab Basic Black Transmission Distance: 0.6PLA BambuLab Basic Blue Gray Transmission Distance: 3PLA BambuLab Basic White Transmission Distance: 5This print uses 5 unique filaments. Substitute as needed. Swap Instructions:Start with GrayAt layer #7 (0.64mm) swap to YellowAt layer #14 (1.2mm) swap to BlackAt layer #18 (1.52mm) swap to Blue GrayAt layer #21 (1.76mm) swap to White for the rest. Boost MeGot a Boost to spare? Every little bit helps the motivation. Thank you!MembershipWant to go commercial or maybe just show some love? Consider signing up to show support!