MakerWorld
Decor
Model downloaden
Cabinet Knob
124
Downloads
25
Likes
66
Makes
This is a simple cabinet knob. I used PLA Silk for it. It takes around 50 min per knob. The bottom half where the 8/32 thread is located has a higher infill for strength, along with 5 walls for the entire part for added strength. Print in the orientation it is downloaded in.
missile150 publiceert ook op
46 extra modellen op 2 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
