MakerWorld
Other Tools
Zum Modell
Cabinet Knob
175
Downloads
20
Likes
110
Makes
One of my coworkers broke a cabinet knob, so rather than go buy one, I was able to design one in 15 minutes and printed in ASA. This will go on a cabinet at my work. It has a 3mm hole for a screw to go into. It is 32mm in diameter and 22mm deep. It is enough to get your fingers behind to pull the cabinet open.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
