Slicer Discord
Cable Bridge - Easy cable management  – 3D-Druckmodell von MakerWorld MakerWorld
Organizers

Cable Bridge - Easy cable management

8 Downloads
13 Likes
7 Makes
Zum Modell
Tired of cables dangling under your desk? The Cable Bridge is a smart, slide-on solution designed specifically for the LINNMON / ADILS Tabletop from IKEA which has a tabletop thickness of 4 cm. No tape, no screws, no need to redo your entire setup. Just slip the Cable Bridge onto the back edge of the tabletop and it’s ready to go. The channel holds your cables neatly and helps keep them off the floor and out of the way.It fits snugly and installs in seconds. It can be removed or repositioned anytime. Best of all: it will also work on any desk with the same 4 cm (1½") tabletop thickness, not just the LINNMON/ADILS model. Also…. Boost MeIf you want you can always give me a boost as it is free!
Kategorie
Organizers
Quelle
MakerWorld
Veröffentlicht
Aktualisiert
Was du zum Drucken brauchst: Mittel Niedrige Konfidenz
Einteilig Hardware nötig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 1/3
Drucker
FDM / FFF
Dateiformat
STL
Material
Nachbearbeitung
Hardware
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!

Ähnliche Modelle

6 Vorschläge
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen