MakerWorld
Other House Models
Zum Modell
Cable Canal (with or without grooves)
24
Downloads
5
Likes
11
Makes
I set about designing another cable channel that is narrower and can also be printed with either two grooves for cables with a diameter of approx. 4.5 mm (e.g. standard network cables) or without them. This is just the complete cable ducts, the part for the switch is not included as it is specifically for the system seen here. Proven click mechanism with good and sufficient hold The standard dimensions are 20cm x 2.4cm x 2.6cm (length x width x height), but can be edited in the slicer. There are two screw holes with a diameter of 4 mm. I hope it helps and you can benefit from it.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
