Cable Guide Clip for XTool D1 Pro

Hello Everybody,This is a cable clip for the XTool D1 Pro.I had the following issue: Sometimes, when the laser is homing, the cables which run from the controller to the gantry get stuck between X stepper and frame which may cause damage to the motors. At first, I wanted to install a drag chain, but this turned out to be way too complicated (extending cables, etc.). So I made this clip which snaps right onto the X-Stepper Motor.The wire harness should be put inside the clip as shown on the image.It seems to have solved the issue pretty well and for almost no expense. Have Fun!