Slicer Discord
Cable guide for A1 and A1mini (Using ptfe :P) – 3D-Druckmodell von MakerWorld MakerWorld
3D Printer Accessories

Cable guide for A1 and A1mini (Using ptfe :P)

1.6k Downloads
360 Likes
941 Makes
Zum Modell
As I don't use AMS or the PTFE tube that comes with my A1, because I prefer a small tube to insert my filament directly into the extruder, my cable was hanging, so I designed this. I'm sharing it in case there's someone else in my situation who would like to try it out.(If you use AMS you can also use it to keep your cable in place ^^) Tip: If, over time, the piece becomes a bit loose, you can fix it with a simple piece of paper. There’s no need to reprint the part. My motto is, “Don’t overcomplicate it if the simple solution works.” Boost MeIf you like the design, help me a lot by giving it a like and giving me some boosts. Thank you so much!
Kategorie
3D Printer Accessories
Quelle
MakerWorld
Veröffentlicht
Aktualisiert
Was du zum Drucken brauchst: Anfänger Niedrige Konfidenz
Warum?
2 Farben
Einteilig 2 Farben / AMS
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 0/3
Drucker
FDM / FFF
Dateiformat
STL
Material
PLA
Farben
2 (AMS/MMU empfohlen)
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!

Ähnliche Modelle

6 Vorschläge
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen