Thingiverse
cable guide for keyboard drawer
door ff29197691
3
Downloads
0
Likes
0
Makes
My keybaord cable need to go from the front side to my computer
But every time I close the drawer, the cable will be clapmed
So I design this cable guide
There is two size of screw
for ver 6
It can clip on any position that is 14 ~ 21mm thick
ver 2 crew iks longer , can be used in 0 ~ 21 mm thick
the screw hole doesn't need support !
or it will be hard to locking the screw
the screw should be printed stand
and doesn't need support ,too
But every time I close the drawer, the cable will be clapmed
So I design this cable guide
There is two size of screw
for ver 6
It can clip on any position that is 14 ~ 21mm thick
ver 2 crew iks longer , can be used in 0 ~ 21 mm thick
the screw hole doesn't need support !
or it will be hard to locking the screw
the screw should be printed stand
and doesn't need support ,too
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!