Thingiverse
Cable guide table hole 60MM
von geniustimer
31
Downloads
33
Likes
1
Makes
I needed to put some holes in the table that could be covered when not in use.
Each hole has a movable cap consisting of two parts.
My advice when printing is to do it with supports and face down.
I hope it helps.
Enjoy!
Each hole has a movable cap consisting of two parts.
My advice when printing is to do it with supports and face down.
I hope it helps.
Enjoy!
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!