Cable Guide
door Diskea
0
Downloads
1
Likes
0
Makes
Simple clip i made to go on my 10.5mm wide microphone stand arm to retain the wires. Snaps in place and can easily be scaled in you slicer if need me. Note the circle/ cable portion is 6.2mm and the square side is 10.2mm so scale accordingly. Snaps in place, best material is abs but pla works fine as well, just a bit harder to install.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
