Cable holder for various diameters

So I decided to make my own cableholder for various diameters because the majority of the cableholders available in Thingiverse are made for a single cable diameter.

How does this works?

1) Install the cable holder using 2 Phillip screws.

2) Put the clips on the wedges (since the wedges width is 3 mm and the internal clip width is 2,5 mm a little bit of force will be neccesary). I recommend to use 3 clips in the wedges 1, 3 and 5.

3) Once the clips are installed, you can slide and/or rotate them to put cables in the gaps between the wedges, so you won't need to take out the clips.

This if my first design uploaded to Thingiverse, hence any feedback to improve the design will be highly appreciated.

If this helped you and you want to support me, you can give give me 1 DOGE to my adress DPWRiXr6EAmZKwXgELUTCHmaiwq5CwoVsA