Thingiverse
Cable holder
door HoneyBaddger
45
Downloads
23
Likes
0
Makes
A cable holder. You need rather small zipties and double-sided adhesive tape.
Print without support, depending on the printer, you would need to clean up the small tunnels to get the ziptie through.
This is just for fun! 100 of these cost about 3€... just sayin.
Print without support, depending on the printer, you would need to clean up the small tunnels to get the ziptie through.
This is just for fun! 100 of these cost about 3€... just sayin.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!