Thingiverse
Cable Holder
by KIO-Design
1
Downloads
0
Likes
0
Makes
A small Print to hold your cables in place, so they don't slide off your Table.
Glue it to a Wall or Table
4 cable holders only take 30 Minutes at 0.1mm layer height.
Glue it to a Wall or Table
4 cable holders only take 30 Minutes at 0.1mm layer height.
KIO-Design also publishes on
17 additional models across 2 more platforms
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
