Cable Management Box

Creates a box meant to hold a power strip and hide/manage cables. Being a box, however, it can hold whatever you want to put in it. You can also design a box bigger than your print bed by splitting with built in connectors.

Totally customizable, figure out how big you need it, set the dimensions, and print!

To test the connector tolerance without printing the whole box, select "Test" in the customizer under "Model", and perhaps also enter a smaller value for width. This will create a test print allowing you to dial in the tolerance value to be used.

Currently limited to a single split, allowing for double your print bed size, but could be extended with a bit of work to allow for arbitrary sizes.