Thingiverse
Cable management clip
by Gwynnevere
0
Downloads
0
Likes
0
Makes
This was printed using a Bambu X1Carbon, using standard Bambu PLA basic. All parts were printed sideways.
-0.2mm standard print layer thickness.
-90% infill resulted in a very strong connection, (please note that if you want it taken apart you need to slide the top out sideways at this infill).
-100% infill gap.
all other settings were standard Bambu settings.
Best results with super dry filament. had a print failure due to too much moisture in the filament, and had to use a food dehydrator to dry it out.
-0.2mm standard print layer thickness.
-90% infill resulted in a very strong connection, (please note that if you want it taken apart you need to slide the top out sideways at this infill).
-100% infill gap.
all other settings were standard Bambu settings.
Best results with super dry filament. had a print failure due to too much moisture in the filament, and had to use a food dehydrator to dry it out.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
