Cable Management / organizer

This is my first attempt at 3D design. I do not yet have a 3D printer, but have one on the way.

This is a cable management clip for organizing cables for under your desk, or elsewhere were cables need to be kept tidy.

Please provide feedback to let me know where improvements could be made, or if you make improvements.

I am hoping that there is enough space to slide/snap cables in and out, and that the plastic will flex a little to allow cables to snap into place, computer power cables may need to be fed through.

Currently set to 50 mm wide, with 2 mm diameter for screw hole.

This is my original design, and is subject to change, as it is still a work in progress.