Thingiverse
Cable management?
22
Downloads
24
Likes
0
Makes
Need an excuse to use your 3d printer(s) to solve a minor problem? Then I have the solution for you.
That said these cable ties are still relatively cost-effective and a very robust solution.
The designs revolved around the idea of a robust solution that could hold many wires securely and could be rewired indefinitely with as little effort as possible.
To make the system you will need some kind of pin, I used a large safety pin. I took inspiration from buses on circuit boards.
That's why I mad a bigger version of the loop part. I used them to use up the extra length in my wires to make the whole system look cleaner.
I could easily print 6 at a time on my CR-10S but your results may vary.
As always feel free to modify to your needs.
That said these cable ties are still relatively cost-effective and a very robust solution.
The designs revolved around the idea of a robust solution that could hold many wires securely and could be rewired indefinitely with as little effort as possible.
To make the system you will need some kind of pin, I used a large safety pin. I took inspiration from buses on circuit boards.
That's why I mad a bigger version of the loop part. I used them to use up the extra length in my wires to make the whole system look cleaner.
I could easily print 6 at a time on my CR-10S but your results may vary.
As always feel free to modify to your needs.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
