Cable Organizer

Remix of frs101 cable organizer. Used frs101 remix as the modification he did with the closing latch is spot on and work very well.
I used frs101's design and filled in the holes and create 2 channels for tie wraps as I don't like using double sided tape and the mounting hole just did'nt line up.
My use case was for cable management for a Next Level Racing chassis, but can be used in any situation.
Depending on the overhang of the clip, tugging too hard on the clip could snap off a small piece where there is no support.
e.g. The clip is a bit wider then the base. If you pull the zip tie too tight it could snap off a small piece where there is no support
(See picture with red circle)
It does not impact the function of the clip and is not noticeable when installed, but for those of us who are bothered by the little things it might drive you nuts.

I printed mine at 20% infill, but did one at 50% where I had thick and tight cables.
Included a long and short version